A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
We're licensed and insured for residential and light commercial interior drainage work across Hudson, NC.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Every system is tested with a hose before we consider the install complete.
Every Hudson, NC Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
A channel is cut along the slab edge, perforated pipe is laid with proper slope, and gravel backfill allows water to flow freely into the drain.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
This option works well as a lower-disruption alternative to full perimeter drain tile in certain Hudson, NC basement layouts.
We treat the cove joint as part of every interior drainage install, not as a separate add-on.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.
Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
Most residential interior drainage installs finish in one to three days depending on perimeter length.
"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Hudson Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Hudson Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Hudson Homeowner
"Clean install, patched concrete matched the existing floor color almost perfectly."
— Hudson Customer
Full perimeter systems make sense when multiple walls show signs of intrusion or as preventive coverage.
We'll recommend whichever fits your basement's finish level and budget.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
An undersized basin cycles the pump too often, so we don't cut corners on sizing.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
Most residential installs finish in one to three days depending on perimeter length and whether cove joint sealing is included.
We install and repair interior drainage systems throughout Hudson and the surrounding Hudson, NC service area, including the zip codes listed below.
Zip codes we serve in Hudson, NC: 28638
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
